beautypg.com

Installation instructions – Hotpoint EG53 User Manual

Page 29

background image

LEVELLING

Two rear wheels and two front feet are fitted which can be adjusted up or down to set the height
(915mm) and level the cooker.
1.

The rear wheels can be raised or lowered from the BACK of the cooker by adjusting the
levelling screws ‘A’ in the plinth.

2.

The front feet can be simply screwed in or out to lower or raise the front of the cooker.

CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.

NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves

VIEWED FROM REAR

STABILITY BRACKET

The back of the cooker has a slot for engagement of a stability bracket, which can
be obtained, as an extra, from your cooker supplier.

CONNECTING TO GAS SUPPLY

The cooker is designed to match the depth of standard 600mm worktops. An
adaptor backplate should, therefore, be fitted within the shaded area shown to
allow the cooker to be pushed fully to the wall.

Connection to the cooker should be made with an approved appliance flexible
connection to BS 669. Hoses connected to LPG should be suitable for LPG and capable of
withstanding 50mbar pressure A length of 0.9 to 1.25m is recommended. The length of
hose chosen should be such that when the cooker is in situ, the hose does not touch the
floor.
The temperature rise of areas at the rear of the cooker that are likely to come in contact
with the flexible hose do not exceed 70˚C.

STABILITY
BRACKET
POSITION

GAS
BACKPLATE
POSITION

125mm

450 mm

635mm

29

SLOT FOR
STABILITY
BRACKET

REAR OF
COOKER

220mm

70mm

INSTALLATION INSTRUCTIONS