Hasbro FurReal Friends Butterscotch Pony 76471 - Manual (Page 2)

ASSEMBLY
Your pony can tell when you’re sitting on her to
have a “ride”! When you sit on your pony, she will
move her head up and down, blink her eyes and
twitch her ears while making soft sounds.
Wait for your pony to stop moving before you take
her into “riding mode.”
When sitting on your pony, tap her hindquarters
with your hand and she’ll go into “riding mode”.
She will make walking sounds and also move her
eyes, ears and head. After a few seconds, she’ll
stop. Just tap her hindquarters to get her
going again!
Watch an
assembly demo
online at www.
furrealfriends.com!
For questions on
assembly,
call Hasbro
Consumer Affairs
at 1-800-327-8264.
“RIDING” YOUR PONY
Brush your pony with her special
grooming brush to keep her coat
healthy.
To clean your pony, gently brush
her with a cloth or soft brush to loosen any dirt.
Then use a slightly damp cloth to remove stains.
• To prevent staining, wipe off dirt immediately.
• Do not get wet; to remove stains use only a
slightly damp cloth.
• Do not use detergent or stain removers.
• If pony gets wet, remove batteries and let dry;
once pony is completely dry, replace batteries.
• Avoid spilling food or beverages on the pony.
• Do not throw or kick the pony, and do not push
sharp objects through the speaker openings.
• Do not leave pony in direct sunlight; high
temperatures will destroy the mechanism.
GROOMING YOUR PONY
Note: If you
have any
concerns or
questions
about this toy,
please do not
return it to the
store. Instead,
call Hasbro
Consumer
Affairs at
1-800-327-8264
for expert advice
and answers.
Tap
hindquarters
Step 1
Pull back head plush. Snap
head onto body.
Step 2
Fasten 2 screws onto the
top of the head-turning
mechanism.
Step 3
Snap in electrical connector
clip from head into body.
Make sure clip side of
connector faces toward
front of pony .
Step 4
B. Snap zipper pull
into clip at end
of zipper.
To unfasten zipper,
press button on
zipper clip to release.
Note
A. Zip head and
body plush
together.
Head
Body
Body
Head
Head
Turning
Mechanism
front
Clip
side
faces
front
of
pony.
Fasten screw
to left side of
head-turning
mechanism.
Step 1a
STEP 1A - VERY
IMPORTANT – this step
helps ensure that your pony’s head
and neck have adequate support.
1 6