HotBrick VPN 800/8 F User Manual

Page 40

HotBrick, Tel: 305-398-0888, Fax: 305-398-5966

settings to correct the problem.

 Enable - If enabled, the WAN port you specify will be used for all outgoing SMTP

traffic. If disabled, either WAN port will be used.

 WAN – Select the desired WAN port to be bound.

Protocol and Port Bindings - Use these settings if you wish to ensure that particular traffic
is sent by a particular WAN port, and thereby a particular ISP account.

 Enable - Enable or disable each item as required.
 Source IP - IP address of the source sending the packets.
 Destination IP – IP address of the destination receiving the packets.
 Subnet Mask – With a subnet mask other than 255.255.255.255, you can make an IP subnetwork

your destination.

 Protocol – Select protocol type used by the traffic you wish to configure.

 Port Range - Enter the beginning and end of the port range used by the traffic you wish to

configure. If only a single port is used, enter the port number in both fields.

 WAN - Select the WAN port you wish this traffic to use.

Protocol and Port Binding List - This list shows the details of all protocol and port configuration data
that are currently defined. You can modify them by mouse clicking the correct row.