HoMedics Automatic Wrist Blood Pressure Monitor BPW-040 User Manual

Page 7

11 12

1. The battery cover is located

along the left side of the
monitor. Remove battery
cover by pressing down
and pulling away from the
monitor.

2. Install batteries according to

the polarity indications inside
the compartment (as shown
in fig. 2). Battery Type: 2
Alkaline LR03 (AAA) size

3. Replace the cover

by inserting it back
into place.

Replace the batteries if:
1. The weak battery

symbol appears in
the display.

2. Nothing appears in the

display when the power is
switched on.

Replace all batteries at one time (as simultaneous
set). Use only 1.5V AAA alkaline batteries.
Remove batteries when unit is not in use for
extended periods of time. Date and time will need
to be reset if batteries are removed or replaced.
Clean contacts on battery and in battery
compartment with a soft dry cloth each time you
install batteries.

INSTALLING BATTERIES

DATE/TIME SET PROCEDURE

1. To adjust the date/time, press the Set button

. The display will show a blinking number

showing the month.

2. Change the month by pressing the button.

Each press will increase the number by one in a
cycling manner. Press the Set button again
to confirm the entry, and the screen will show
a blinking number representing the day of the
month.

3. Change the date and time as described in

Step 2 above, using the button to change
the numbers and the Set button

to confirm

the entries.

blinking month

increasing month

confirm the entry

repeat process to set date and time

Press the button

Note: Batteries are hazardous waste. Do not dispose of

them together with the household garbage.

BPW-040_A.indd 13-14

12/22/09 12:37 PM