Operating instructions (continued) setup menu, English, System – Hitachi CMP420V2 User Manual
Page 43: Color system av1, Av3 av4 video input av1, Av2 (1st step), Av2 (2nd step)
ENGLISH
OPERATING INSTRUCTIONS (continued)
SETUP MENU
Picture
Audio
Timer
Function
Setup
Language
Select
OK Set
Setup
System
System 2
Color System
Video Input
Audio Input
Scart Output
Monitor
RGB1
DVI-STB
RGB2
Component
HDTV
Select Set Return
OK
Setup
System
System 2
Color System
Video Input
Audio Input
Scart Output
Monitor
RGB1
DVI-STB
RGB2
Component
HDTV
Select Set Return
OK
OK
MENU
OK
Setup
Color System
AV1
Auto
AV2
NTSC-M
AV3
PAL-M
AV4
PAL-N
Select Return Exit
Setup
System
System 2
Color System
Video Input
Audio Input
Scart Output
Monitor
RGB1
DVI-STB
RGB2
Component
HDTV
Select Set Return
OK
OK
Setup
Video Input
AV1
Auto
AV2
Composite/Component
AV3
Auto
AV4
S.Video
Select Return Exit
OK
Setup
Audio Input
AV1
Stereo
AV2
L/Mono
AV3
Stereo
AV4
L/Mono
Select Return Exit
Selected characters
Setup hint
System
System1 System2
Do not change the original setting.
(System1 : Europe/Asia, System2 : North America)
Color System
AV1
Auto NTSC-M
PAL-N PAL-M
This should correspond to the color system of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
AV2
(Same to AV1)
AV3
AV4
Video Input
AV1
Auto HDTV SDTV/DVD
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
AV2 (1st step)
RGB Composite/Component
This should correspond to the signal mode of the signal from the
equipment that is connected to AV2 video input terminal.
AV2 (2nd step)
Auto HDTV SDTV/DVD
This step should be set only when [Composite/Component] is selected on
the 1st step. And the procedure is same to AV1.
AV4
S.Video Composite
• If the signal from the equipment that is connected to AV4 Scart input
terminal is S.Video or Composite, set this to correspond to that signal.
• If the signal is RGB, it will be automatically recognized and this setting
will have no effect.