beautypg.com

Operating the oven, Before using the oven, Using standard oven racks – LG Studio 30 Inch Smart Double Electric Wall Oven Owners Guide User Manual

Page 17: Using gliding oven racks

background image

17

OPERATION

EN

G

LIS

H

Adjusting or Cancelling the Timer

1

Touch the remaining time next to the clock

icon in the display.

2

To cancel the timer, touch the Reset icon in

the popup. Then touch OK.

3

To adjust the time, scroll the numbers in the

popup until the desired time appears. Then

touch OK.

4

The remaining time in the display is adjusted.

Operating the Oven

Before Using the Oven

NOTE

• Because the oven temperature cycles, an oven

thermometer placed in the oven cavity may not

show the same temperature that is set on the

oven.

• It is normal for the convection fan to run while

preheating during a regular bake cycle.

• The convection fan motor may run periodically

during a regular bake cycle.

• The heat turns off if the door is left open during

baking. If the door is left open for longer than 30

seconds during baking, the heat turns off. The

heat turns back on automatically once the door

is closed.

• Avoid opening the oven door more than

necessary during use. This helps the oven

maintain temperature, prevents unnecessary

heat loss, and saves on energy use.

Oven Vent

Areas near the vent may become hot during

operation and may cause burns. Avoid placing

plastics near the vent as heat may distort or melt

the plastic.
It is normal for steam to be visible when cooking

foods with high moisture content.

WARNING

• Do not block the vent opening at the bottom of

the oven.

Using Standard Oven Racks

The racks have a turned-up back edge that

prevents them from being pulled out of the oven

cavity.

CAUTION

• Replace oven racks before turning the oven on

to prevent burns.

• Do not cover the racks with aluminum foil, or

any other material, or place anything on the

bottom of the oven. Doing so will result in poor

baking and may damage the oven bottom.

• Only arrange oven racks when the oven is cool.

Removing Racks

1

Pull the rack straight out until it stops.

2

Lift up the front of the rack and pull it out.

Replacing Racks

1

Place the end of the rack on the support.

2

Tilt the front end up and push the rack in.

Using Gliding Oven Racks

The gliding racks slide in and out on a frame. This

keeps heavy cookware level and prevents it from

sliding forward when the rack is completely

extended.

CAUTION

• Place oven racks in the desired location before

turning on the oven to avoid burns.

• Do not cover the racks with aluminum foil, or

any other material, or place anything on the

bottom of the oven. Doing so will result in poor

baking and may damage the oven bottom.

Reset icon

œš†”ˆ•U‰––’U‰––’GGwˆŽŒGX^GGm™‹ˆ SGqœ“ GYZSGYWYXGGZaY^Gwt