Explore Scientific Weather Station with Three Wireless Sensors - Manual (Page 6)

SNOOZE FUNCTION
1. At the set time, alarm signal rings.
2. During the alarm, press the [ SNZ / LIGHT ]
button to delay the alarm by 5 minutes.
3. To stop the alarm, press any other button, ex-
cept for [ SNZ / LIGHT ] button.
4. The alarm will start again at the next alarm
time, unless you turn off the alarm function by
pressing the [ ALARM ] button to display the
alarm time first, then press the [ ALARM ] but-
ton once more until the alarm is set to off.
TEMPERATURE AND HUMIDITY
The indoor temperature is always displayed in
the centre of the screen. To receive outdoor te-
mperature you can connect up to 3 outdoor sen-
sors to the main unit.
Press the [ CH ] button to toggle between Chan-
nel 1-3.
MANUAL MEASUREMENT DISPLAY
1. Press [ UP ] button to display the max. and min.
temperature.
2. Display order: Current values > MAX (highest
values) > MIN (lowest values)
3. When displaying highest or lowest values, press
and hold [ UP ] button to delete all saved values.
BACKLIGHT
Press [ SNZ / LIGHT ] to activate backlight.
SPECIFICATIONS
MAIN UNIT:
Dimensions
141 x 21 x 124 mm (L x W x H)
Weight
220 g (Exclude batteries)
Power:
3x AAA (LR03) 1.5V batteries
TEMPERATURE:
Indoor temperature display range:
0°C to +50°C (32°F to 122°F)
Outdoor temperature display range:
-50°C to +70°C (-48°F to 158°F)
HUMIDITY:
Indoor/outdoor humidity range:
20% - 95% RH
6
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press [ ALARM ] to display the alarm time.
2. Press and hold [ ALARM ] button to enter alarm
setting mode.
3. The setting parameter will flash.
4. Press [ UP ] or [ DOWN ] button to set the de-
sired data.
5. Sequence of setting: Hour Minute Exit
5. Press [ ALARM ] button to confirm setting and
exit.
6. Alarm will turn on automatically when alarm
setting is finished.
TURN ON/OFF ALARM
Press [ ALARM ] to display the alarm time. Press
the [ ALARM ] button once more to turn on/off the
alarm.