Alfatron Tile Bridge (4 to 6") - Manual (Page 2)

Make a cut out on the ceiling board,
using the ceiling speaker or template
for the diameter.
Mount the speaker from underneath the ceiling board so that the back can
sticks out at the top
.
Place both tile bridges on either side of the speaker back can.
Please ensure that they are placed horizontally with the 600mm
side of the ceiling tile.
1
2
3 4
Move the tile bridges towards each other until they
touch the back can
sides.
Twist the speaker brackets out wards so that they rest on the
tile bridges flat surface, and then tighten the screws in place.
5
As an extra precaution, you can attach safety cable s to the tile bridge, these need to be able to hand l e
the weig h t of the assembly and be attach ed it to the slab to act as a harness should the ceiling rail fail at
any point.
8
With the self tapping screws provided, lock the assembly to the ceiling rails .
7
Lift your complete assembly with the ceiling tile and install it on the ceiling as you would install a ceiling tile .
6
www.alfatronelectronics.com