Nissin i400 TTL Flash for Cameras - Manual (Page 9)

Shooting i400 automatically
Canon cameras
Nikon cameras
(Program), (Full Auto), (Aperture priority),
(Shutter priority) or (Manual);
(Program), (Full Auto), (Aperture priority),
(Shutter priority) or (Manual);
Set i400 to the camera’s hotshoe and press the on/ off switch to power on.
Indicator Lamp A on.
Rotate the Function dial to “A” mode.
i400 is now set for the camera’s automatic flash control system.
Press the shutter button of your camera halfway to focus the subject.
Take the picture. i400 is fired and the result is immediately shown on the camera’s
LCD display.
When you change the focal length, the power zoom flash head of i400 immediately
sets its position to match the lens focal length you selected.
The flash illumination coverage of i400 responds to the lens focal length of 24mm
to 105mm (35mm film camera standard).
In all of the camera's shooting modes listed above, i400 will fully work in TTL
automatic-flash system.
Shutter speed, aperture and flash mark ( ) are indicated in camera’s view finder.
9