MSolutions MS-6U41A 5-Input Extender Set - Manual (Page 6)

06 [email protected] | www.m4sol.com
MS-6U41A USER GUIDE
RS-232 Control
The MS-6U41A can distribute bi-directional serial commands between the transmitter and receiver
to allow for control commands to be sent alongside USB KVM.
Each unit is fitted with a 3-pin phoenix connector block that will need the serial TX, RX and Ground
pins terminating into for serial pass-through. The link has the ability to transparently send any type
of serial data as both pieces of equipment are able to communicate using the same baud rate, stop-
gap, and parity.
USB
This KVM extender allows for USB 3.0 compatible and USB-C peripherals including cameras, touch
screens, smart boards, hard drives, games controllers, USB audio devices, printers, scanners, and
HID’s (mouse or keyboard) to be distributed over a distance of up to 100m to a USB-C host device
on the far side of the link.
The extender supports transparent true plug and play USB2.0 pass-through without the
requirement of software or driver son the extender kit.
A maximum combined data transfer of 320Mbps can be achieved over the link.
The Micro-USB connections on both Transmitter and Receiver are utilised for firmware updating
and are reserved for future CloudOS control.
Note: the USB-C connectivity does not support high-bandwidth video data from a laptop / tablet to
a display due to the limitation of available bandwidth.
Power
The MS-6U41A uses bi-directional PoC (Power over Cable) to provide power from either the
Transmitter or Receiver unit to the far side of the link over the Cat cable. Please only use the
supplied 12V/2A DC PSU supplied with the MSolutions MS-6U41A to power the unit