Savage ModMaster Adaptable Speedlight Softbox (25") - Manual

®
MODMASTER ADAPTABLE SPEEDLIGHT SOFTBOX SETUP & USAGE
1. Place softbox on large flat surface, mount side
down, and release velcro strap.
2. Pull open edges of softbox, place both hands
inside against left and right sides of material to
spread softbox open.
3. Place one hand firmly over the base of an arm
(assembly can begin with any arm) and push
down until arm clicks into place.
4. Proceed to the next arm, and work your way
around until all 8 have been snapped in.
5. The Savage Adjustable Softbox comes with both internal and external diffusers.
Attach internal diffuser to the velcro tabs located about 4.5” from the top of the softbox.
6. Attach external diffuser to the velcro strip around the top outer edge of the softbox.
If mounting to a studio strobe with a Bowens mount, the softbox is
now ready for use.
®
OPEN SOFTBOX SNAP ARMS INTO PLACE ATTACH DIFFUSERS
SNAP INTO PLACE INNER DIFFUSER
SPEEDLIGHT MOUNTS
ADAPTER RELEASE LEVER
SPEEDLIGHT MOUNT
GRIP HANDLE RELEASE
UMBRELLA RECEIVER
TILT ADJUSTMENT KNOB
TIGHTEN TO LIGHT STAND
OUTER DIFFUSER
SETUP
- ASSEMBLY CAN BEGIN AT ANY POINT INSIDE THE SOFTBOX AND WITH ANY ARM
SPEEDLIGHT USAGE
- MOUNT UP TO 5 SPEEDLIGHTS AND AN UMBRELLA
ATTACH SPEEDLIGHT ADAPTER
ATTACH COMFORT GRIP HANDLE
DISSASEMBLE COMPONENTS
COLLAPSE SOFTBOX
1. Attach speedlight adapter to softbox mount, and
turn the adapter clockwise until it snaps into place.
2. Use the side grip screws to tighten the orange
padded disks to each side of your speedlight.
1. Line up the track at the top of the comfort grip with
the speedlight carriage on the opposite side of the
mount from the release lever.
2. Press the release lever up with the front edge of
the comfort grip and then slide the comfort grip onto
the track until the release lever pops down to lock
into place. To release, pull up the release lever and
slide handle off.
For more light output, detatch speedlight adapter from
softbox and mount up to 5 speedlights, combined
with a shoot through or bounce back umbrella.
SLIDE
ONTO TRACK
1. Remove diffuser panels by pulling gently away from velcro strips.
2. Place the softbox on a large flat surface, front side facing down.
3. Remove comfort grip handle by pressing release lever and sliding off.
4. Remove the speedlight adapter from the softbox by pushing the small
side lever, and turning the adapter counter clockwise to unlock.
BREAKDOWN
Note: The release button will not release the softbox arms
unless the arm has been pulled back to relieve the tension
on the button.
1
4
5
2
3
5. With one hand, gently lift up on the arm to relieve tension.
6. With the other hand, press black release button to collapse arm.
6. Repeat step 5 & 6 until all 8 arms have been released.
7. Place softbox and accessories into carry bag for safe storage.
GRIP ARM &
GENTLY PULL UP
5
FIRMLY PRESS
RELEASE BUTTON
6
professional photography made simple
800.624.8891 s
avage
U
niversal
.
com