beautypg.com

Using the badger unleashed – Interfit Badger Unleashed 2-Light Backpack Kit User Manual

Page 8

background image

Using the Badger Unleashed

Beep Button

Press the “BEEP” button to turn on or off the beeping sound for button presses, flash power adjustments,

and flash refresh notifications.

Optical Slave Cell

The Optical Slave Cell allows the Badger Unleashed to be triggered from the flash pulse of another unit.

Press the “CELL” button to toggle on and off the Optical Slave Cell.

NOTE: Using the Optical Slave Cell requires direct line-of-sight between the lights. The Optical Slave Cell

can only be used in Manual mode in moderate to low ambient light.

Shooting Modes

When shooting with the Interfit TTL remote, select from a manual shooting mode or the TTL (Through-The-

Lens) mode. Press the button beneath “MODE” on the TTL remote to toggle between shooting modes.

Sync Modes

When shooting with the Interfit TTL remote, select from three different sync modes. Press the button

beneath “SYNC” to toggle the sync mode to first curtain, second curtain, or HSS.

NOTE: Nikon users switch between 1st and 2nd-curtain sync via the camera and enable HSS by increasing

the shutter speed on their camera with the flash sync mode set to “Auto FP”. Sony users must set their

camera flash mode to “Wireless Flash” for the remote to communicate properly with the camera.

Using HSS (High-Speed Sync)

Use the Interfit TTL remote to toggle the shooting mode of your Badger Unleashed to “HSS”. This shooting

mode will allow you to use shutter speeds of up to 1/8000 sec. and trigger the flash. The power range

readout will change to 8.0-10.0. These output levels do not directly correlate with the 8.0-10.0 flash in

manual mode. There will be a noticeable decrease in flash output, as the Badger Unleashed will divide the

power into a series of lower power flashes to allow for correct exposures at high shutter speeds.

www.interfitphotographic.com 7

BEEP

CELL

MODE

This manual is related to the following products: