页 10 – Godox MS200-V Studio Flash Monolight (3-Light Kit) User Manual

Page 5

Memory Function

The sound button is used for deciding whether there is sound reminder for ready flash
after recharging. When the buzz indicator is on the LCD panel, the buzz function is
working; when it is disappear, the buzz function is not working. A “BI” sound will be
heard when it’s fully charged.

E0 The temperature sensor is in error.

Key Combination

Buzz Function

Synchronously press the GR/CH button and the S1/S2 button can turn on/off the built-in
wireless transmission. If there are no wireless and channel indicators displayed on the
LCD panel, the built-in wireless transmission is off. On the contrary, the built-in wireless
transmission is on. Synchronously press the S1/S2 button and BUZZ button to recover
factory settings.

Alarm Display

E3 The inner capacitance and voltage are too high.

Note:

If E0 or E3 alarm occurs, sounds like BIBI and rings per 0.5 second, please send

the flash to the professional maintenance point if hearing the alarm sound.

The device is equipped with memory function for the panel setting. It will help remember
the panel setting 3 seconds after you set it. When starting up the flash next time, the
panel setting will be the same as that before powering it off.

Wireless Control Function

The flash unit has built-in 2.4G wireless transmission, which can be used together with
X1 and XT16 flash trigger.

Over-Temperature Protection Function

Synchronously press the Button and the Button can turn on the
built-in wireless transmission and the < > is displayed. If there are other wireless flash
systems nearby, you can change the channel IDs to prevent signal interference. The
channel IDs of the master unit and the slave unit(s) must be set to the same.

The flash will auto off its firing function and the temperature alarm display

< > will be

blinking when the flash's inner temperature is over high. When the flash's temperature is
below 50

℃

, all the flash functions will be normal.

Long press the <

GR/CH

Button for 2 seconds until
the channel IDs is blinking.

Turn the Select Dial to choose

the channel from

Press the <

SET

> Button to

confirm.

Short press the <

GR/CH

Button for 2 seconds until
the group IDs is blinking.

Turn the Select Dial to choose

the group from

Press the <

SET

> Button to

confirm.

Setting the Communication Channel

Setting the Communication Group

The flash unit is built in with a Wireless Control Port so that you can wirelessly
adjust the power level of the flash and the flash triggering.
To control the flash wirelessly, you need a FT-16 remote control set (on-camera
and on-flash). Insert its receive end into the Wireless Control Port on the flash
and insert the transmit end into the camera hot shoe. Settings made on
the hotshoe-mounted transmit and receive ends will be
wirelessly communicated to the flash. Then you can press
the camera shutter release button to trigger the flash. You
can also hold the transmit end at hand to control your off-
camera flash.

For full instructions on the use of FT series remote control, see its user
manual.

- 15 -

- 16 -

OFF