GRAM FSI 3225-94 N/1 - Manual (Page 56)

6 EN
3 Installation
B
Please remember that the
manufacturer shall not be held
liable if the information given in the
user guide is not observed.
Points to be considered when
re-transporting your freezer
1. Your freezer must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, and etc. have to
be fastened securely by adhesive tape
against any jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the rules
of transportation printed on the
package must be followed.
Please do not forget…
That recycled material is an indispensable
source for the nature and for our national
resources. If you would like to contribute to
the recycling of the packaging materials,
you can get further information from the
environmental bodies or local authorities.
Before operating your freezer
Before starting to use your freezer
check the following:
1. The interior of the freezer has to be dry
and it is possible for the air to circulate
freely at the back of the appliance.
2. Clean the interior of the freezer as
recommended in the “Maintenance and
cleaning” section.
3. Plug the freezer into the wall outlet.
4. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
5. Front edges of the freezer may feel warm.
This is normal. These areas are designed to
be warm to avoid condensation.
Important:
• The connection must be in accordance
with national regulations.
• The power cable plug must be easily
accessible after installation.
• Extension cords and connector
must not be used for connection.
Electric connection
Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
B
A damaged power cable must be
replaced by a qualified electrician.
Disposing of the packaging
The packaging may be dangerous for
children. Keep it out of the reach of
children or dispose of it by classifying it in
accordance with the waste instructions.
Do not dispose of it together with the
normal household waste.
The packaging of your freezer is
made from recyclable materials.
Disposing of your old freezer
Dispose of your old freezer without
harming to the environment.
• You may consult your authorized
retailer or the recycling depot in your
municipality about the disposal of
your freezer .
Before disposing of your freezer , cut out
the electric plug and, if there are any locks
on the door, make them inoperable in order
to protect children against any danger.
Placing and Installation
1. Install your freezer in a place that
allows ease of use.
2. There must be appropriate air
ventilation around your freezer in order to
achieve an efficient operation.
3. Place your freezer on an even floor
surface to prevent jolts.
4. The freezer can be installed indoors, at
temperatures up to -15 ° C. This gives you
the option to install a freezer such as a
holiday home, garage or utility room.
Important! The magnet on the door
must not be removed!