GRAM KSU 3136-50/1 - Manual (Page 83)

EN 8
3 Installation
B
Please remember that the
manufacturer shall not be held liable
if the information given in the user
guide is not observed.
Points to be considered
when re-transporting your
freezer
1. Your freezer must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, etc. have to be
fastened securely by adhesive tape
against any jolt before packaging the
freezer.
3. The packaging must be tied with
thick tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget…
That recycled material is an
indispensable source for the nature
and for our national resources.
If you would like to contribute to the
recycling of the packaging materials,
you can get further information from
the environmental bodies or local
authorities.
Before operating your
freezer
check the following:
1. The interior of the freezer has to be
dry and it is possible for the air to
circulate freely at the back of the
appliance.
2. You can install the 2 spacers as
illustrated in the figure. The spacers
will provide the required distance
between your freezer and the wall in
order to allow the air to circulate. (The
illustrated figure is only an example
and does not match exactly with your
product.)
3. Clean the interior of the freezer as
and cleaning" section.
4. Plug the freezer into the outlet.
5. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
6. The front edges of the freezer may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
Electric connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in
accordance with the national
regulations.
The power cable plug must be easily
accessible after installation.
Extension cords and sockets with
several plugs must not be used for
connection.
B
A damaged power cable must be
replaced by an authorised electrician.