beautypg.com

İhlas Aura microControl User Manual

Instant water heater, User manual, Warning

background image

TECHNICAL SPECIFICATIONS

Voltage

: 230 VAC

Frequency

: 50-60 Hz

Power

: 7 kW

Operatable min. water pressure

: 2.5 mSS

Inlet Controlled Pressure

: 0 Pa (model 105MC...)

Outlet Controlled Pressure : 600 kPa (model 105MC..C)

Min. Operating Pressure

: 25 kPa (2.5 mSS)

Max. Operating Pressure

: 600 kPa (61 mSS)

Flow rate

: 100-240 L/hour

Size (H, W, D)

: 330x210x110 mm

Net Weight:

: 2 kg

Protection Class

: l

Zmax

: 0.21 + j 0.13 Ώ

Protection aganist moisture : IP44

MODEL

105 MC...

105MC..C

USER MANUAL

Dear Customer,

Thank you for choosing our product. We hope that
microControl Water Heater, which has been manufac-
tured in modern facilities in pursuant to high-quality
standards, will provide the best efficiency for you.
Therefore, please read the entire user manual thorough-
ly and keep it for future reference.

WARNING!

The water inlet of this appliance shall not be connected
to inlet water obtained from any other water heating
system.

This appliance is not to be used for a potable water
supply.

INTRODUCTION OF WATER HEATER

• It is under the consumer's own responsibili-

ty to suit electrical and water installation to

the water heater.

• For your appliance with 7 KW heating power

being able to be mounted, have its necessary

electrical and water installation made by

qualified electricians and plumbers.

• The electrical connection of the device

should be grounded. It should never be used

in buildings which do not have an earth, have

an inadequate earth or an earth which fails to

comply the rules. Otherwise, our company

shall not be responsible from problems to be

occurred.

• Your appliance is only for household use. It

should not be used for commercial or

industrial purposes (at hairdressers which

require continuous hot water, and workplaces

such as construction sites, small scale

workshops etc.).

• Your appliance can not be connected to

main water supply in the flat, should be

connected to where authorized service

deems suitable.

Authorized Service only makes the

electrical connection of the appliance to the

completed installation, and its initial starting.

• Do not mount your water heater where the

water in its inside may freeze. In case the

water freezes, do not operate your appliance.

• The appliance should be connected to

minimum 32 Ampere-Automatic fuse.

• When your appliance is operating, do not

operate other devices which have more than 1

KW power (oven, iron, washing machine,

dishwasher etc.).

• Only use the hose and fittings given with the

appliance when installing. Do not use

pre-used hose or fittings.

• Always contact with Authorized Service for

all kind of malfunctions, maintenance and

spare part procurement.

• In places where the water pressure is more

than 6 bars, it is recommended to insert a

pressure reducer regulator to cold water inlet

of your water heater. The hoses or pipes

which shall be directly connected to the

installation should be resistant to 6 bar

operating pressure.

• According to the season's temperature, inlet

water temperatures will vary. You may supply

hot water as you wish by adjusting the water

temperature selection stepping switch and

water inlet amount.

• Power supply of the water heater is

deactivated in case of inadequate pressure or

water cut. When it reaches the adequate

pressure, power supply is activated again.

• This appliance can be used by children form

8 years and above and people with reduced

physical, sensory or mental capabilities or

lack of experience and knowledge if they

have been given supervision or instruction

concerning the use of the appliance in a safe

way and understand the hazards involved.

Children must not play with the appliance.

Cleaning and maintenance by the user must

not be performed by children, unless they are

over 8 years old and supervised. Keep the

appliance and its cord out of reach of children

aged less than 8 years.

• This device must be mounted vertically.

• Power selector should be at “0” position

when the appliance is not used.

IMPORTANT WARNINGS

1. Front Casing

2. Power selector switch

3. Shower head

4. Adjistable holder

5. Fixed holder

6. Outlet hose

7. Tap

8. Inler hose

9. Lock nut

10. Rear casing

11. Mounting Holes

Instant Water Heater