İhlas Aura Wdry Wet & Dry - Manual (Page 7)

NOW, YOUR DEVICE IS READY TO VACUUM WET SPILLS.
In the event of a wet spill in your home, your device can be used to remove liquids from
your floor.
Use the following steps convert your device from sweeping mode to wet vacuuming mode.
Wet spill vacuuming
WARNING
Do not use your device to vacuum any hazardous liquids like
flammable liquids, corrosives, acids, oil based liquids, etc...
Lift the head unit from
the dirt collection
tank.
1
Tighten the filter
securing lock
clockwise.
5
Replace head unit on
dirt collenction tank
and lock the clips.
6
Remove the dust bag
from the dirt
collection tank.
2
Remove the cartridge
filter by turning the lock
anticlockwise and
pulling outwards.
Instead of cartridge
filter, fasten sponge
filter in-place by
inserting.
3 4
Attach suction hose
to inlet connector and
press on button for
power.
7 8
You can vacuum the
accumulated water
with the end of the
suction hose.
WARNING
During vacuuming, if the water level is exceed in the tank, the sound of the device will be
increased. In that case, unplug your device and discharge the water from the tank.
WARNING
• Turn off the on/off switch and unplug the
device. Remove all attacment and suction-hose
from the device.
• Empty the dirty water reservior, wipe with a
cloth to remove dirt, rinse thoroughly with warm
water and allow to dry completely before
storage.
• Remove sponge filter, rinse and allow to dry
completely.
• Rinse and clean all parts and accessorries
thoroughly and allow to dry completely.
• To clean the suction-hose, flush clean by
running hot tap water through it and allow to
dry completely before using again or storage.
Maintenance must be performed by an authorized service technician.
Cleaning and maintenance