MIDEA 29.3 cu. ft. French Door Bottom Freezer - Manual (Page 9)

09
EN
Installing the Water Line
Installing the Water Line
• Water line installation kits are
available as an addional accessory
from your dealer or at a local
hardware store.
1. First, shut off the main water supply
line and turn the ice-maker off.
2. Locate the nearest cold water supply
valve.
3. After connecting the water supply to
the water valve, turn your main water
supply back on and flush several
gallons of water to clear the water
supply line.
Cold water line
Pipe clamp
Shut off walve
Water line installation kit
Power cord hook
Water line
Water connector
Water connector
Water tube
Connecting the Water Line to The
Refrigerator
• There are several items that you
need to purchase to complete this
connection.
• You will find these items sold as a kit
at your local hardware store.
1. First, close the main water supply and
locate the nearest cold water line.
2. Second, connect the water valve to
the cold water line.
3. Turn water valve on and check for
any leakage.
4. When moving the refrigerator, you
can hang the power cord on the
power cord hook.
Connecting the Water Line to A
Drinkable Water Source
• If your water line is not drinkable,
please add an external water filter.
• If you must repair or disassemble the
water line, cut off the plastic tubing
to make sure you get a snug, leak-
free connection.
ATTENTION
The minimum inlet water pressure: 276kPa.
The maximum inlet water pressure: 689kPa.
WARNING: Connect to potable water supply
only. New hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.