ProSoft Technology MVI46-DFNT - Manual (Page 39)

MVI46-DFNT ♦ SLC Platform Configuring the MVI46-DFNT Module
EtherNet/IP Client/Server Communication Module User Manual
ProSoft Technology, Inc. Page 39 of 177
October 12, 2010
2.6 [DF1 Pass-Through Port]
This section defines the configuration for the DF1 pass-through port on Port 2
(the third port).
2.6.1 Enabled
Yes or No
This parameter determines if the server will be utilized by the module. If a value
of "Yes" is entered, the server will be used. Any other value will disable the
server.
2.6.2 Local Station ID
0 to 254
This parameter specifies the local station ID for all DF1 messages sent to this
port. A value of 255 is not permitted as this is the broadcast address. The
application will only accept messages with this node address.
2.6.3 Protocol
F (Full duplex) or H (Half duplex)
The value selected should match that set for the SLC processor.
2.6.4 Termination Type
BCC or CRC
This parameter specifies the error checking for all DF1 messages. Enter BCC or
CRC.