PLANET VIP-156PE User Manual
Voip analog telephone adapter, User’s manual
Table of contents
Document Outline
- Chapter 1 Introduction
- Chapter 2 Preparations & Installation
- Chapter 3 Network Service Configurations
- Chapter 4
VoIP Telephone Adapter Configurations
- Phone Book
- Call Forward
- SNTP settings
- Volume Setting
- Block Setting
- Auto Answer (For VIP-157)
- Caller ID settings
- Dial Plan Settings
- Flash Time Setting
- Call waiting Settings
- T.38 (FAX) Settings
- Hot line Settings
- Alarm Settings
- LAN Settings
- PC Settings
- DDNS Settings
- VLAN Settings
- DMZ Settings
- Virtual Server
- PPTP Settings
- Service Domain Settings
- Port Settings
- Codec Settings
- Codec ID Setting
- DTMF Setting
- RPort Settings
- Other Settings
- STUN settings
- Auto Configuration
- Encrypt Config
- PTT Settings
- Cancel without to tag
- MAC CIone Setting
- Tone Settings
- Advanced Settings
- System Authority
- Save & Reboot
- Firmware Upgrade
- Auto Upgrade
- Reset to Default
- Reboot without saving
- Appendix A Voice Communication Samples
- Case 1: ATA to ATA connection via IP address
- Case 2: (Peer-to-Peer mode) VIP-157S Port 1 to Port 2 communications
- Case 3: Voice communication via SIP proxy server – SIP-50
- Case 4: Voice communication via IP PBX system – IPX-2000 (Auto-config)
- Case 5: Call Forward Feature_Example 1
- Case 6: Call Forward Feature_Example 2
- Case 7: Call Forward Feature_Example 3
- Case 8: Call Forward Feature_Example 4
- Case 9: Auto Answer Feature_IP to PSTN
- Case 10: Auto Answer Feature_PSTN to IP
- Appendix B The method of operation guide
- Appendix C VIP-156/VIP-156PE/VIP-157/VIP-157S Specifications