DE DIETRICH DVH930 - Manual (Page 26)

55
EN 14 / IF OPERATING ANOMALIES OCCUR
• POOR OPERATION
Problem Possible C auses What to do ?
Constant filling
A lot of waste on the large filter
at the end of the cycle.
-drain tube has become dislod-
ged.
-drain outlet is located too low
with respect to the appliance
(see fault table 12).
-filters and sink drain blocked
due to excess dirt. -check the draining installation.
-remove and clean the filters and
the bottom of the sink drain.
Remove the largest food
residues from the dishes before
loading them into the dishwasher.
Traces of rust on stainless steel - Quality of the stainless steel
not dishwasher-safe (knives in
particular)
- Use “special dishwasher-safe”
cutlery.
- Check that the stopper on the
salt container is closed correctly.
• POOR DRYING RESULTS
Problem Possible C auses What to do?
A lot of droplets on the glasses. - Lack or insufficient amount of
rinsing product.
- The dose has not been distrib-
uted.
- Positioning of the items.
- Check the indicator light and
fill the tank completely.
- If the tank is not empty after
approximately 60 washings,
call a technician.
- To alleviate the phenomenon,
arrange the items to restrict
water retention as much as
possible. Leave the door ajar
for a few minutes, if possible
Droplets on plastic items, Tefal
coatings, etc. - These insulating items have a
low calorific mass.
- Arrange them preferably in the
upper basket.
Poorer drying on rapid
programmes - On rapid programmes, the drying
temperature and drying period are
reduced to cut down the duration
of the cycle as much as possible.
- Select a rapid programme
carefully or leave the door ajar
for a few minutes.
Condensation on the wall of the
inside door or the tub. - Condensation may form on the
walls, particularly after the
appliance has cooled down
(sound insulation increases the
phenomenon)