Silvercrest SHBS 3.7 A1 User Manual

Page 81

6.1 Changing the cutting attachments

WARNING! Risk of injury!
Switch off the hair and beard trimmer5, before you attach or
remove the attachments.

• Figure A: to remove the attachments12,3,4,11,13

use your thumbs to press the attachment towards the rear
of the hair and beard trimmer5.

• Figure B: to attach the attachments, put the lower flap of

the attachment12,3,4,11,13 into the slot in the hair
and beard trimmer5 and press the upper part of the at-
tachment against the hair and beard trimmer until it audi-
bly locks into place and sits firmly in position.

6.2 Changing the comb attachments

Pushing on
• To attach the comb attachments2 +1 carefully slide the

appropriate comb attachment over the hair or beard trim-
mer attachment12 /13. Press the lower part of the comb
attachments2 firmly until they lock into place.

Removing
• To remove the comb attachments2 loosen the comb at-

tachment at its lower end and pull it off the hair and beard
trimmer5.

• Slide the comb attachment1 for the beard trimmer attach-

ment13 upwards from the hair and beard trimmer5.

BB.5$B%ERRN6HLWH0LWWZRFK'H]HPEHU