Silvercrest SHBS 1000 A1 - Manual (Page 13)

10 SHBS 1000 A1
GB
Thinning your hair
You can use this function to reduce the volume of your hair because only part
of the hair is gripped and trimmed.
♦ To thin your hair, clip the thinner add-on 8 onto the trimmer block from the
front until it engages. When doing so, the thinner add-on 8 must protrude past
the trimmer head teeth.
Cutting the edges of the hairline, neck and sideburns
♦ Turn the appliance round so that the rear side is facing upwards.
♦ Place the edge of the trimmer block without a cut length add-on 7 at the
required height along the hairline.
♦ Switch the hair and beard trimmer on and move it downwards.
Trimming and cutting your beard
♦ Select a cut length add-on depending on the required beard length.
♦ Now trim your beard in stages.
Cleaning and care
DANGER
Danger to life due to electric shock!
► Pull the power supply unit 6 out of the power socket before cleaning the
appliance.
► Never touch the power supply unit 6 with wet hands, especially when
plugging it in or unplugging it.
► Always keep the power supply unit 6 and the cable dry.
CAUTION
Possible damage to the appliance.
► The hair and beard trimmer may never be immersed in water or other fl uids
for cleaning, since the appliance is not watertight. If this is done, live parts
(batteries) can be damaged.
► Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces.
► Clean the housing exclusively with a soft damp cloth and a mild dishwashing
liquid.
♦ Switch the hair and beard trimmer off by pressing the ON - OFF switch 3 .
♦ Disconnect the cable from the appliance and pull the power supply unit 6 out
of the power socket.
IB_86722_SHBS1000A1_LB4.indb 10 IB_86722_SHBS1000A1_LB4.indb 10 18.03.13 16:49 18.03.13 16:49