Silvercrest SHBS 1000 A1 - Manual (Page 95)

95 GB
Always cut off small amounts at a time.
Guide the hair and beard clippers slowly through the hair.
Hold the device so that the selected cutting length comb attachment
6 is always lying as flat on the scalp as possible.
Always cut from the neck towards the top of the scalp or from the
forehead and temples upwards towards the centre of the scalp.
Q
Cutting without an attachment
CAUTION! DANGER OF INJURY!
The cutter head is very sharp!
Without a cutting length comb attachment 6 in place, the device can
cut hair to a length of between 0.5 mm and 2.5 mm. Slide the sliding
switch
2 to finely adjust the cutting length to the desired value.
Note: By varying how and at what angle you hold the hair clippers,
you can depart from the cutting lengths indicated in these instructions
for use or marked on the attachment / device.
Q
Thinning hair
This attachment allows you to reduce the volume of hair by only picking
up and cutting part of the hair.
Push the thinning attachment 7 on to the blade set 1 from the
front to thin out the hair. This attachment reduces the volume of the
hair.
use use