Silvercrest SDB 2200 D2 - Manual (Page 31)

- 28 -
Housing and sole of the iron
Potentially fatal danger!
Remove the plug before cleaning the device.
There is a risk of electric shock!
Risk of physical injury!
Allow the appliance to cool down before cleaning
it. Otherwise, there is a risk of burns!
Attention! Property Damage!
Do not use abrasive, aggressive or chemical clea-
ning agents.
They can damage the surface and also lead to irre-
parable damage to the appliance.
• Clean the housing with a soft, dry cloth only.
• Clean the ironing sole
q using a damp cloth
and a mild, non-scouring detergent.
Storage
Store the appliance in a clean, dust-free, and dry
location after it has cooled down.
Troubleshooting
Steam iron producing little or no steam:
The reserves of water in the steam iron are depleted.
Fill the water tank with tap water (See "Filling the
water tank").
The steam iron does not get hot:
• The steam iron is not plugged in or is not switched
on. Insert the plug into a wall power socket and
adjust the thermostat
8 to the desired ironing
temperature.
• The steam iron is defective. Arrange for the steam
iron to be repaired by qualified specialists.
Disposal
Do not dispose of the appliance in your
normal domestic waste. This appliance
is subject to the provisions of European
Directive 2012/19/EU.
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
IB_103235_SDB2200D2_LB2.qxp 10.11.2014 18:14 Uhr Seite 28