Silvercrest SHBS 1000 A1 - Manual (Page 15)

15 GB/IE
Before first use / Use
j Insert the connector plug of the plug-in mains adapter into the
socket on the underside of the hair and beard clippers.
j To avoid injury and damage to the device, always switch off the
device before you connect it to the mains supply.
j Insert the plug-in mains adapter (wide voltage range 100 - 240 V)
into a mains outlet socket that meets the requirements of the device.
j After 1 - 2 seconds you can switch on the device by pressing the
ON / OFF switch
3 . If the device does not start working immedi-
ately, switch it off again and wait for about 1 minute before you
switch it on again.
j If you wish to charge the batteries in this way without using the
charging station
5 , then do so only with the device switched off.
Q
Use
Q
Prolonging the life of the
rechargeable batteries
For a longer rechargeable battery service life, it is recommended that
the batteries are completely discharged before they are recharged. To
completely discharge the battery, run the device until it comes to a
complete stop.
Q
Tips
The hair to be cut should be clean and dry.
j Comb your hair through carefully to remove any knots.
j Place the hairdresser’s cape or a cloth around the throat and neck
to prevent hair from dropping into the collar.