Silvercrest 4-LD3905 - Manual (Page 19)

- 35 -
Restart
Press the REC button on the backside of the alarm clock for 4
seconds to restart radio time signal reception. The hands of the
alarm clock will now move to the 12:00:00, 4:00:00 or 8:00:00
o'clock position and stop. The alarm clock will now begin to
receive the DCF 77 radio time signal. If radio time signal
reception is not possible, the time must be set manually.
Manual time setting
If radio time signal reception is not possible, the time can be set
manually:
•
Press and hold SET for 4 seconds.
• Press SET briefly to move the hands forward by 1 minute.
•
Press and hold SET to use speed setting.
•
If the SET button is not pressed for 8 or more seconds, the
alarm clock will exit setting mode and the set time will be
activated.
LC display
If radio time signal reception is
successful, the LC display will
alternate between temperature and date every 20 seconds. If
radio time signal reception failed, the temperature will appear
continuously. If the alarm is activated, the bell symbol will appear.
Light
Press the SNOOZE/LIGHT button on top of the alarm clock to
activate the light briefly.
Alarm
To set the alarm time, turn the alarm setting knob on the backside
of the alarm clock in the direction of the arrow. Move the switch
on the side of the alarm clock to the "ON" position.
If the alarm is activated, the bell symbol will appear on the LC
display. The alarm will sound at the set time and the alarm
frequency will increase 3 times in intervals of 10 seconds.
Move the alarm switch to "OFF" to deactivate off the alarm. If the
alarm is not turned off, it will sound again in 12 hours.
- 36 -
Snooze
Press the SNOOZE/LIGHT button on the top of the alarm clock to
activate the snooze feature. The light will be activated briefly and
the alarm will stop. After 5 minutes, the alarm will restart.
Reset
If the alarm clock malfunctions, the electronics of the alarm clock
can be reset by pressing the recessed RESET button with a pointed
tool (a screw driver for example). The hands of the alarm clock
will move to the 12:00:00 position and the date will be reset to
1.1.
Cleaning instructions
Clean the alarm clock with a soft, dry and lint-free cloth. A glasses
cleaning cloth is ideal.
Declaration of Conformity
If used as intended this product conforms to the basic standards of
§ 3 and the other relevant provisions of the FTEG (Section 3 of the
R&TTE directive). The declaration of conformity may be requested
here: [email protected]
Disposal of the electronic appliance
This alarm clock may not be disposed of with normal
household waste. Dispose of the alarm clock at an approved
disposal facility or at your local recycling centre. Please observe
the current rules and regulations when disposing of the appliance.
Contact the disposal system if in doubt.
Disposal of the batteries
Please dispose of your batteries properly in containers especially
set up at retailers. Batteries do not belong in household waste.
Dispose of the batteries at an approved disposal facility or at your
local recycling centre. Contact the disposal system if in doubt.
digi-tech gmbh warranty
This alarm clock includes a 3 year warranty starting on the day of
purchase. In case of defects of this alarm clock you have, by law,