Silvercrest SMK 15 A1 - Manual (Page 7)

SMK 15 A1 5
– always keep the mains lead 3 or car
lead 11 away from moisture.
• If liquid should enter the appliance,
disconnect the power supply
immediately and have the appliance
repaired by a qualified technician. You
will find the service address in
“8. Warranty” on page 9.
• Never take hold of the mains lead 3 or
car lead 11 when your hands are wet.
• Always unplug the connection leads
from the power supply first and then
from the appliance.
• If you are not using the appliance for a
prolonged period of time, unplug the
mains lead
3 or car lead 11 . This is the
only way to ensure the complete absence
of electric power and to protect against
the appliance being switched on
accidentally.
• If the appliance is used in boats,
caravans, camper vans etc., the power
supply must be protected during mains
operation by an earth-leakage circuit-
breaker.
3.5 For the safety of your child
Warning! Ensure the packaging
foil does not turn into a deadly trap
for children. Packaging foils are
not toys.
3.6 Protection against damage
Caution! The following information is
intended to protect the appliance against
damage.
• Never pull the plug out of the wall socket
or cigarette lighter by means of the
leads. Always take hold of the plug.
• To avoid overheating, the appliance
must not be operated near to heat
sources or in direct sunlight.
• Ensure that the ventilation slots for the
air inlet 15 and outlet 13 as well as the
exterior ventilation slots 16 are never
covered. Maintain a distance of 10 cm
from walls and other objects.
• Corrosive substances or substances
containing solvents must not be
4. Operating the Appliance
4.1 Using the appliance for the first
time
1. For reasons of hygiene, clean the
appliance thoroughly inside and out
before using it for the first time or if it
has not been used for a long time (see
“5.1
Cleaning the appliance” on
page 7).
2. Select a location that is well ventilated
and protected from heat and sunlight.
3. Place the appliance on a level, non-slip
surface.
4. Turn the function selector 6 and the
voltage selector 7 to the OFF position.
4.2 Selecting a voltage
Use the voltage selector 7 to select the
required voltage:
230V: operating on the mains
12V: operating on a car electrical
system
OFF : appliance is switched off.
RP62053 MiniCooler LB6 Seite 5 Mittwoch, 12. Januar 2011 10:45 10