Livarno 10270B/ JL-T009 - Manual (Page 7)

7 GB
winter, it should be cleaned and stored in a
dry, warm location.
The solar light is intended as an outdoor
accent light.
Safety instructions for
rechargeable batteries
RISK OF AC-
CIDENT AND DANGER TO LIFE
FOR INFANTS AND CHILDREN!
Rechargeable batteries are not intended to be
in the hands of children. Do not leave the bat-
teries lying around. They may otherwise be
swallowed by children or pets. If accidentally
swallowed seek immediate medical attention.
CAUTION! EXPLOSION HAZ-
ARD! Use only rechargeable bat-
teries of the recommended type.
Other rechargeable or single-use batteries
could explode during charging.
FIRE HAZARD! Do not allow re-
chargeable batteries to short-circuit.
Otherwise the rechargeable batter-
ies may overheat, become a fire hazard or
explode.
CAUTION! EXPLOSION HAZ-
ARD! Never throw rechargeable
batteries into fire or water.
Outdated or used rechargeable batteries may
leak chemicals which damage the product.
Remove, therefore, the rechargeable battery
when the lamp is not required for any length of
time.
WEAR PROTECTIVE GLOVES! If
they come into contact with skin,
leaked or damaged rechargeable
batteries could cause chemical burns; you
should therefore wear suitable protective
gloves at all times if such an event occurs.
Only use rechargeable batteries of the correct
size and and the recommended type (see
section ”Technical Data”).
Ensure correct polarity, indicated in the battery
compartment.
Functionality
The integrated solar cell of the article converts so-
lar radiation into electrical energy and stores it in
the NiMH rechargeable battery. Switches on the
light as it begins to get dark. The built-in LED is an
energy-saving illuminant with a very long life. The
light duration depends on the amount of sunlight,
the angle of light on the solar panel and the tem-
perature (the battery capacity is temperature-de-
pendent). A vertical angle of light at temperatures
above the freezing point is ideal. The rechargeable
battery will only achieve its maximum capacity
after several charging and discharging cycles.
Start-up
Mounting the light
Rotate the solar cell housing 2 counter-
clockwise out of the lampshade 1 .
Set the ON/OFF switch 6 to the position
marked „ON“ to allow the product to switch
on in the dark.
Insert the solar cell housing 2 into the
lampshade 1 and turn clockwise to secure.
Attach the lampshade 1 to the lamp body 3 .
Attach the ground stake 4 to the lamp body
3 with the tip pointing down.
Your solar light is now ready for use.
Installing the light
Push the assembled solar light far enough into
the ground (lawn, flower bed) so it is stable.
Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will damage
the product. In order to achieve the best result,
set the solar garden lamp up in a place where
the solar cell will get direct sunlight for as long
as possible.
Make sure the solar cell is not impacted by
other light sources, e.g. yard- or street lighting,
or the light will not switch on at twilight.