Parkside PDKS 120 B3 - Manual (Page 10)

10 GB
Assembly / Bringing into use
Slide the blade guard 9 into the desired posi-
tion and fix it in that position by tightening the
knurled nuts
10 .
Q Attaching the feet
12
(see Fig. B)
Attach the feet 12 from below through the
mounting holes in the device‘s base plate.
Q Attaching the dust blow tube
1
(see Fig. C)
Screw the fan tube 1 clockwise and hand tight
into the designated opening.
Q Bringing into use
CAUTION! Make sure that the device is
switched off before you connect it to the mains supply.
Always switch on the electrical power tool before
moving the workpiece against it. Otherwise
there is the risk of kickback.
Setting up the device:
Grab the device at the position labelled
“Please lift here” to position the device.
Switching on the device:
Press the green ON button 4 .
Switching off the device:
Press the red OFF button 3 .
Q
Setting the stroke rate
Turn the stroke rate controller 2 clockwise to
increase the stroke rate.
Turn the stroke rate controller 2 anticlockwise
to decrease the stroke rate.
NOTE: Be aware that too high a stroke rate leads
to the saw blade heating up, an increase in wear
of the saw blade and burn marks on the material.
Select a saw speed suitable for the material
being sawn.
Maximum
speed Medium
speed Minimum
speed
Thick woo-
den board Straight
cut Normal
fretsaw
work -
Thin woo-
den or
plastic
board Straight
and curved
cuts Normal
and intri-
cate
fretsaw
work Intricate
fretsaw
work
Q Tilting the saw table
6
(see Figs. D, E)
Unscrew the angle setting screw 5 .
Tilt the saw table 6 until the desired is
reached.
NOTE: The angle can be read off the angle
scale
6 a .
Retighten the angle setting screw 5 .
Q Inserting / removing the
saw blade
7
DANGER OF INJURY!
Pull the mains plug out of the socket before you
carry out any task on the device,
Inserting the saw blade 7 :
Lift up the clamping lever 13 .
Insert the saw blade 7 through the opening in
the saw table 6 .
Ensure that the teeth of the saw blade 7 point
forwards and downwards.
Suspend the saw blade 7 in the bottom
blade mount 14 .
Then hook the top pin of the saw blade 7 in
the recess provided for this purpose in the top
saw blade mount
8 .
Lower the clamping lever 13 to tension the saw
blade 7 .
Turn the clamping lever 13 horizontally clock-
wise to increase the tension.
Bringing into use / Maintenance and cleaning / Service / Warranty / Disposal