Parkside PBS 900 A1 - Manual (Page 12)

12 GB
Operation
Material / type of
work removing paint /
varnish
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) ––
Preselected rotation
speed
high (5-6)
Material / type of
work Sanding varnish
Coarse finish
(Grit grade)
150
Fine finish (Grit grade) 320
Preselected rotation
speed
low (1-2)
Material / type of
work rust removal
Coarse finish
(Grit grade)
40
Fine finish (Grit grade) 120
Preselected rotation
speed
medium / high (3-4)
Material / type of
work Plastic
Coarse finish
(Grit grade)
120
Fine finish (Grit grade) 240
Preselected rotation
speed
low / medium (2-3)
Material / type of
work Non-ferrous metals
(e.g. aluminium)
Coarse finish
(Grit grade)
80
Fine finish (Grit grade) 150
Preselected rotation
speed
medium / high (3-4)
Q Using the sander in
a fixed mounting
The fixed mounting kit allows you to use the device
for sanding vertically or horizontally by fastening
it on to a flat stable surface (e.g. workbench).
Sanding horizontally (see Fig. E):
j Place the belt sander on to the mounting frame
12 and guide the dust extraction spout 5
through the opening of the mounting frame 12 .
Tighten the screws 16 .
j Place the two clamp plates 13 on to the holes
provided on the opposite side and screw the
clamp plates tight with the provided screws.
j Insert the pins of the screw clamps 14 into the
holes on one of the long sides of the mounting
frame
12 (see Fig. E). Attach the mounting
frame 12 by tightening the screw clamps 14 .
Sanding vertically (see Fig. F):
j Insert the pins of the screw clamps 14 into the
holes on one of the short sides of the mounting
frame
12 . Attach the mounting frame 12 to a
flat, stable surface (e.g. workbench) by tighten-
ing the screw clamps
14 .
j Place the belt sander on to the mounting frame 12
and guide the dust extraction spout 5 through
the opening of the mounting frame 12 . Tighten
the screws 16 .
j Place the two clamp plates 13 on to the holes
provided on the opposite side and screw the
clamp plates tight with the provided screws.
Q
Tips and tricks
j Never use the same sanding belt to sand wood
and metal.
j Worn or ripped sanding belts can damage
the workpiece. Change sanding belts at the
appropriate time.
j Keep the sanding belt properly tensioned so
that it does not hang down too much and
become unusable due to nicks, creases etc.