LW Scientific BioVID - Manual (Page 3)

Avoid:
Installing in humid or dusty places.
Installing in places where there is radiation.
This could damage CCD and other components and
cause malfunction.
Installing in places where there are strong magnetic
fields and electric signals.
Installing in places where the camera would be
subject to strong vibrations.
P. 770.270.1394 F. 770.270.2389 865 Marathon Parkway Lawrenceville GA 30046
Precautions
Mounting on Microscope
Installation and Storage
Before using, make sure of power supply and connection of
video output. Power supplied without voltage stabilization or
the voltage maintained at 12V±10% DC may cause
damage.
While operating, if any abnormal condition or a malfunction is
observed, stop using the camera immediately and then call
your local dealer.
Do not disassemble the camera and never touch parts
inside the camera.
Do not drop the camera or subject it to shocks and
vibrations to avoid possible damage.
When attaching or removing the lens, handle with care in
order that moisture and dust does not enter the camera.
Do not shoot any source of bright light. if the object contains
very bright areas, bright vertical or horizontal lines may
appear on the screen. This is called “smear”, a
phenomenon which often occurs with solid-state pickups,
and is not a malfunction.
Do not point the camera at the sun. This could damage the
camera whether it is operating or not.
Do not install the camera where the temperature could
exceed the allowable range. Be sure the ambient
temperature is less than 40°C for long-term continuous
operation.
Never expose the camera to rain and water.
Operating Handling
This device complies with Part 15 of the FCC rules. Changes or
modifications not approved by ABC could void the user’s
authority to operate the equipment.
Information for USA
Recommended camera
settings for use on a
microscope, slit lamp or
endoscope.
Lens Manual
AGC On
Shutter Auto
White Balance ATW Back Light OFF
Special
Sharpness High
Contrast On
Power requirement DC12V-DC13V
Power consumption 2.5 Watt
Operating temperature -10C to +50C
(14F to 122F)
Operating humidity less than 85% relative
Storage temperature -20C to +60C
External dimensions 41(w)x41(h)x51.6(d) mm
1.6(w)x 1.6(h)x2.1(d) in
Weight 140 g(0.31 lbs)
Supplied Accessories
C-mount adapter 1
Operation manual 1
Power adapter 1
BNC to RCA Cable 1
Optional lens* 1
*(if ordered)
Note: If used continuously, be certain to operate at less than
40C for long-term stable performance.
For mounting on an trinocular microscope, with C-mount, use the included 5mm
spacer. If mounting to a eyepiece, we have included an 8mm TV Lens and eyepiece
adapter. Using this, you can mount the BioVID over nearly any optical device,
including slit lamps, copal scopes, and microscopes.
3