Polaris 2015 Slingshot - Manual (Page 40)

38
PRE-RIDE INSPECTIONS
Fuel Level
1. Position the vehicle on a level surface.
2. Turn the ignition switch to the ON position.
3. Observe the fuel level in the fuel gauge. See
page 24.
4. Refuel as needed. See page 41 for fuel
specifications.
Steering
1. Position the vehicle on a level surface.
2. Turn the steering wheel full left, then full
right. The action should be smooth, but not
loose.
Front Suspension
Inspect the front suspension for oil leaks or damage. Verify smooth suspension operation.
Rear Suspension
1. Check rear shock absorber movement to ensure the correct amount of suspension travel
and ground clearance. Refer to the specifications section beginning on page 84.
WARNING! Inadequate ground clearance could result in components contacting the ground, causing
loss of control and serious injury or death. Always ensure ground clearance is at specification.
Drive Belt
1. Check the drive belt teeth for stones or
other debris.
2. Inspect drive belt condition. If you
discover cracks, broken teeth or frayed
edges, replace the drive belt before
riding. See the SLINGSHOT Service
Manual or an authorized dealer.
Fasteners
1. Inspect the entire vehicle chassis and engine for loose, damaged or missing fasteners.
Tighten loose fasteners to the proper torque.
NOTE: Refer to the specifications section of this manual or the service manual for fastener torque
values, or see your dealer.
2. Always replace stripped, damaged or broken fasteners before riding. Use genuine
SLINGSHOT fasteners of equal size and strength.
Fuel Level
Drive Belt