Atlantic Water Gardens FBKIT1 - Plumbing Kit - Manual (Page 3)

3
3/4” PVC
STANDPIPE
(not included)
STANDPIPE
SEALANT
3/4” INSERT X
3/4” SOC 90˚
3/4” KINK
FREE TUBING
Step 2:
6’ of ¾” non kink tubing is included in
this kit. Tubing must be cut to length
on site based on the requirement of
the installation. Begin by installing
one end of the tubing to the barbed
outlet of the ball valve. Loop the tub-
ing into the second plumbing channel
and cut it to the desired length. Insert
the barbed end of the ¾” elbow into
the open end of the tubing.
Step 3:
Place the decorative item (Urn,
column, or drilled boulder) on the
fountain basin and position directly
over the ¾” elbow. Run the ¾” PVC
standpipe (not included) through the
decorative item and into the socket
end of the ¾” elbow. Seal the open-
ing around the standpipe with the
supplied standpipe sealant. Standpipe
sealant is an EPDM based product
that will remain pliable and can be
reused.
Step 4:
Atlantic’s Pro Series Fountain Basins
have a recessed pocket that allow
1½” conduit sleeve to be installed
within the radius of the basin. This
feature allows access to the pump
cord and low voltage wiring when
surrounding the basin with pavers or
other hardscape materials. A 1½”cord
stopper is included to plug the top of
the sleeve to prevent gravel and other
debris from entering the conduit.