ZeeVee Zvb701 (DVB-T/C) - Manual (Page 5)

Zvb701-EU Configuration Guide
|
Page 5
Basic Installation
Factory default settings allow Zvb701 modulators to
broadcast up one unencrypted HDMI source on RF channel
21 for reception at connected HDTVs.
We recommend using the most updated version of
firmware. You can find the latest version on the Support
section of our website.
Beginning setup
1. Apply power.
2. Connect an HDMI video source to the HDMI input port of
the Zvb701, using an HDMI cable (which is sold separately).
For Teletext, connect a composite (yellow) cable from the
video source to the Caption port.
3. Optional – Connect the Analog Audio if the digital audio is
not present on HDMI.
Tuning your channel at the HDTV (Auto Scan)
1. Connect the Coaxial Output of the Zvb701 to your RF network.
If the RF power for your network is too high, you will
observe video breakup.
2. Set the RF Input on the TVs to DVB-T (default) or DVB-C
with the Symbol Rate 6740 KS/sec.
3. Enter the RF number to tune
directly to the channel. (Refer
to Default Channel Lineup for
default information.)
If you cannot tune directly to
the channel at this point, it is
because most TVs will require
you to run a full Auto Scan.
4. Run the Auto Scan through the
menu system of your HDTV to
find the channels.
Back of Zvb701 Modulator
Ethernet to network or
directly to computer
Composite
Video
Unencrypted
HDMI Out
Analog
Audio
fo
r
T
ele
tex
t
only
Coax cable connects
to coax network
Video Source
Unencrypted HDMI
Video Source
RF Output
+25 dBm V
DEFAULT CHANNEL LINEUP
DVB-T Factory
Defaults Logical
Channel #
Ch. 21 (474 MHz) 1
Optional DVB-C
Channel Plan Logical
Channel #
Frequency 85 MHz 1