OpenEye CM-410 - Manual (Page 27)

28561AA 17
PRESET
Function Max. 127 positions can be stored as Preset position. The Preset number can be assigned from 1 to
128, but 95 is reserved for starting OSD menu.
Camera characteristics (i.e. White Balance, Auto Exposure) can be set up independently for each
preset. The label should be left blank and "Camera Adjust" should be set to "GLOBAL" as default. All
characteristics can be set up in the OSD menu.
Set Preset [1~128]
Run Preset [1~128]
Delete Preset To delete Preset, use OSD menu.
SWING
Function By using the Swing function, you can make the camera move between two Preset positions repeatedly.
When the swing function runs, the camera moves from the preset assigned as the 1st point to the
preset assigned as the 2nd point in a CW (Clockwise) direction. Then the camera moves from the
preset assigned as the 2nd point to the preset assigned as the 1st point in a CCW (Counterclockwise)
direction.
If the preset assigned as the 1st point is the same as the preset assigned as the 2nd point, the camera
will turn 360
° in a CW (Clockwise) direction, then 360° in a CCW (Counterclockwise) direction.
Speed can be set up from 1 °/sec to 180°/sec.
Set Swing To set Swing, use OSD menu.
Run Swing Method 1) [Swing NO.+10]
Method 2) [Swing NO.+140] ex) Run Swing 3 : [13]
ex) Run Swing 3 : [143]
Delete Swing To delete Swing, use OSD menu.