MEGAPOWER ML131 - Manual (Page 25)

25
Transporting the Pico Projector
The DLP Pico Projector is a highly sophisticated piece of electronic equipment
that is sensitive to impact, excessive heat, cold and humidity. When transporting
the Pico Projector, use a protective bag or use the original packing carton to
minimize shock and impact.
Store and transport the Pico Projector at temperature between 0 and 140 degrees
Fahrenheit (-17 to 60 degrees Centigrade). Avoid storage in automobiles during
seasonal temperature extremes. Automobile interior temperatures can exceed
160 degree Fahrenheit (70 degrees Centigrade) in summer. If the Pico Projector
has been exposed to extremely hot, cold or humid conditions, allow it to stand at
room temperature for 30 minutes before use. Extended use of the Pico in high
temperature environments may cause a reduction in brightness of the projected
image.
Troubleshooting Guide
If you are having a problem operating the Pico Projector, first make sure you
have set it up according to the Section on Setting Up your Pico Projctor. You
should also check the adjustments and the INPUT connections. Verify that all
power is switched on. Before calling for service, check the troubleshooting
suggestions in this Section.
Problem
Solutions
The Mouse Cursor does not move
Battery remaining power too low
There is no sound from speaker
Set volume to a higher setting
Unable to power off unit
with the aid of a thin pointed instrument (e.g.
toothpick) to activate the reset switch