MBM Corporation Paper Drill 200 single spindle - Manual (Page 4)

4
2. Using Illustration No.2, install the Table Assembly (Illustration No. 3) to the body of the
machine by sliding the table from left to right so as to place the metal table channel (H)
located on the bottom of the table assembly astraddle the four (4) traverse bearings (I)
located on the traverse rails (J) of the machine.
ILLUSTRATION #2
Loosen the setscrew in the end stop collar (J) (Illustration No. 3) on the stop bar and rotate the table
traverse stops (I), located on both ends of the stop bar, to the operating position. Using hand pressure,
squeeze the end stop collar and the next stop collar inside the stop collar rod bracket and retighten the
setscrew in the end stop collar. The stop bar should be unable to move in the bracket.