Maytag MMV4184AAW Installation - Manual (Page 16)

16
STEP 5: Install The Mounting Plate
The Oven Must Be Connected To At Least One
Wall Stud.
1. Place the mounting plate against the rear wall as described in
step 5 item 1.
2. Using a pencil, put dots through slots F and G, and through
holes H and I. Remove the mounting plate and draw lines
extending through the points. This will give the location and
size of the box cutout for the rear wall duct.
S Attach the exhaust adaptor to the rear mounting plate by
sliding it into the guides at the top center of the plate on the
wall side. Push in securely until it is past the top locking
tabs and in the lower locking tabs. Take care to assure the
damper hinge is installed so that it is at the top and that the
damper swings freely.
S Carefully guide the exhaust adaptor, now attached to the
mounting plate, into the house duct. Before using the
screws to attach the plate to the wall. This will assure
proper alignment for installation.
S Return to step 5, item 3 to continue. After completing the
installation of the mounting plate, again check the rear
damper for free movement to assure it will operate properly.
Figure 28
Figure 29
Exhaust Adaptor
Slide exhaust
adaptor into
guides on
rear panel.
Locking
Tabs
Guides
Mounting Plate
(wall side)
Damper
(hinge side up)