Denon AVR-1508 - Manual (Page 42)

Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Multi-Zone
Inf
or
mation
Tr
oubleshooting
ENGLISH
Remote Control Unit Operations
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
[MODE
SELECTOR 1]
[MODE
SELECTOR 2]
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.
1
Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
b Set to the AUDIO side for the CD, iPod/NETWORK or TAPE/CD-R/
MD position, and to the VIDEO side for the DVD/VDP, VCR, SAT/
CABLE or TV position.
2 Set [MODE SELECTOR 2] to the component you want
to operate.
3
Operate the component.
b For details, refer to the component’s operating instructions.
b Some models cannot be operated with this remote control unit.
[ZONE2 OFF]
[NUMBER]
[MAIN ON]
[Front]
[Rear]
Remot
e Contr
ol
Operating DENON Audio
Components
Operating Preset Components
1
Set [MODE SELECTOR 1] to “AUDIO”.
2 Set [MODE SELECTOR 2] to the position for the
component to be operated (CD, iPod/NETWORK or
TAPE/CD-R/MD).
3 Operate the audio component.
b For details, refer to the component’s operating instructions.
b While this remote control unit is compatible with a wide range
of infrared controlled components, it may be the case that some
component models cannot be operated with this remote control
unit.
1
Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
b Set to the AUDIO side for the CD, iPod/NETWORK or TAPE/CD-R/
MD position, and to the VIDEO side for the DVD/VDP, VCR, SAT/
CABLE or TV position.
2
Set [MODE SELECTOR 2] to the component to be
registered.
3
Press [ZONE2 OFF] and [MAIN ON] at the same time.
The indicator starts flashing.
4
Press [NUMBER] and input the 3-digit number of the
brand of the component to be preset. The numbers
are shown in the Preset Code Table (vEnd of this
manual).
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
Presetting
• DENON and other makes of components can be operated by
setting the preset memory.
• Operation is not possible for some models.