MacroSystem Quick-Photo - Manual (Page 17)

!
The indicator to show that ANY effect settings has been used will be a tick next to the
catogory used.
!
11 Finish
When all the settings are made use the “Finish" button (18). First you can chose whether
the slide show is inserted AT THE END of the current storyboard, or the storyboard should
be cleared – DELETING everything in it and replacing it with this new slide show.
Please be careful as slide shows often, but not always, go at the end of a long
session of video. So the default to add it to the end is fine (you can always make a
scene of it, Gold software, and move it later) but if you clear the story board you
may remove 100’s of scenes by mistake and the new v7 undo buttons do not
reverse this action!
Then there is a pre-calculation of the Photo Show before your previous selection is applied
– Pictures 23.
! !
Pictures 23
| P a g e 17