La Crosse Technology WS-9782 - Manual

1
WIRELESS 915 MHz TEMPERATURE STATION
Instruction Manual
This product offers: INSTANT TRANSMISSION is the state-of-the-art new
wireless transmission technology, exclusively
designed and developed by LA CROSSE
TECHNOLOGY.
INSTANT TRANSMISSION offers you
an immediate update (every 8 seconds!) of all your
outdoor data measured from the transmitters: follow
your climatic variations in real-time!
2
INVENTORY OF CONTENTS
1. Wireless Temperature Station (WS-9782U-IT)
2. Wireless Temperature Sensor (TX40U-IT) and mounting bracket.
3. Instruction Manual
Stand
Hanging hole
Battery
compartment
LCD
Display
Function Keys
3
SETUP
1. First, insert the batteries to the transmitter (see “How to install and replace
batteries in the Temperature transmitter” below).
2. Within 30 seconds of powering up the transmitter, insert the batteries to the
Temperature Station (see “How to install and replace batteries in the
Temperature station” below). Once the batteries are in place, all segments of
the LCD will light up briefly. Following the indoor temperature, the Weather
Girl icon and the time as 12:00 will be displayed. If they are not shown in LCD
after 60 seconds, remove the batteries and wait for at least 60 seconds before
reinserting them. Once the indoor data is displayed user may proceed to the
next step.
3. After the batteries are inserted, the Temperature Station will start receiving
data signal from the transmitter. The outdoor temperature should then be
displayed on the Temperature station. If this does not happen after 2 minutes,
the batteries will need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 915 MHz transmission however, this should under
4
good conditions be a distance no more than 200 feet (60 meters) between the
final position of the Temperature Station and the transmitter (see notes on
“Positioning” and “915 MHz Reception”).
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
STATION
The Temperature Station uses 3 x AA, IEC LR6 1.5V
batteries. When batteries need to be replaced, the
low battery icon will appear on the LCD. To install
and replace the batteries, please follow the steps
below:
1. Lift up the battery compartment cover.
2. Insert batteries observing the correct polarity
(see marking).
3. Replace compartment cover.
5
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
TRANSMITTER
The Temperature transmitter uses 2 x AAA, IEC LR3, 1.5V
batteries. When batteries will need to be replaced, the low
battery icon will appear on the LCD of the Temperature Station.
To install and replace the batteries, please follow the steps
below:
1. Remove the battery compartment cover.
2. Insert the batteries, observing the correct polarity (see
marking).
3. Replace the battery holder to the unit.
Note:
When changing batteries in any of the units, all units need to be reset by following
the setup procedures. This is because a random security code is assigned by the
transmitter at start-up and this code must be received and stored by the
Temperature Station in the first few minutes of power supplying.
6
FUNCTION KEYS
The Temperature Station has only two easy to use function keys.
SET key
x Press and hold for about 3 seconds to enter the Manual setting mode.
+ key
x Press to make adjustment in the setting mode.
x Press and hold to reset all MIN/MAX records
+ key SET key