La Crosse Technology WS-9118U - Manual (Page 5)

5
DETAILED SET-UP GUIDE
BATTERY INSTALLATION
A. REMOTE TEMPERATURE/HUMIDITY SENSOR
1. Remove the battery cover by sliding the cover down.
2. Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems
make sure they do not spring free).
3. Replace the battery cover by sliding upwards. Be sure battery cover is on securely.
B. INDOOR WEATHER STATION
1. Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of
the battery cover, then push up and pull out on the battery cover.
2. Observe the correct polarity, and install 3 AA batteries.
3. Replace the battery cover.
Note: Immediately after the batteries have been installed, the
LCD (Liquid Crystal Display) will flash. Within 15 seconds
the indoor temperature, indoor relative humidity, and the
weather icons (sun and clouds) will be displayed. If not,
remove batteries for 10 seconds and reinstall. If the outdoor
temperature is not displayed within four minutes, remove
batteries from both units, wait 30 seconds, and reinstall
making sure to install batteries into the remote temperature
sensor first. The time will show 12:00 and start searching for
the WWVB signal. If it successfully receives the time signal
(usually at night), it will display the correct time (default time-
zone is Eastern). You will need to adjust the time zone to
match your local time.
Battery cover
Battery
compartment