Dixon 1998 - Manual (Page 19)

OPERATION INSTRUCTIONS
The Dixon ZTR requires only two drive levers to control braking, turning, speed, and direction.
On initial operation, set throttle speed on slow & operate with mower blade "OFF".
To avoid "over-controlling" the mower, use a light touch on the drive levers. Slight
movements using fingertip control is all that is necessary.
Engage parking brake before starting engine.
STARTING INSTRUCTIONS:
1. Parking brake must be on, control levers swung out, and
blade drive disengaged.
2. Move throttle control to "Choke" position if engine is cold, full
throttle if warm.
3. Insert ignition key and turn to "Start" position. When engine
starts, release ignition key. Key will return to "Run" position.
4. Move throttle from "Choke" to desired speed position.
5. Release parking brake.
6. Swing levers in.
NOTE: While mowing throttle control should be set to the
MAXIMUM or wide open setting to insure adequate
cooling of the engine and to maintain mower deck blade
speed.
Engine cannot be restarted when blade drive is
engaged, the parking brake is off, or levers are swung
in.
Safety switches stop engine when operator leaves seat
while mower blade is engaged.
Always turn engine off when leaving mower. DO NOT
rely on safety switches.
Page 16