Kanguru Clone 4HD User Manual
Page 7
KanguruClone HD
- 7 -
Things to remember:
• The KanguruClone HD is powered by an internal power supply that is
controlled by a rocker switch located at the rear of the unit.
• The KanguruClone 12HD is essentially three KanguruClone 4HD units in
one. Each one of these three units has its own individual power switch.
While operating, make sure that all three individual power switches are in
the on position. Operating the unit with an individual power switch in the
off position can cause configuration problems. You should leave all three
individual power switches in the on position and use the master power
switch to turn the entire unit on or off.
Master Power Switch
Individual Power Switches
• The KanguruClone HD supplies power to all drives during a cloning
session. There is no need to connect an external power source to the
drives. The unit can supply up to 1.5A at 12V and up to 1A at 5V to each
drive.
• It is OK to connect and disconnect Master or Target drives while the
KanguruClone HD is powered on. However, do NOT connect or
disconnect drives during a cloning session. The yellow status light will turn
on to indicate that the unit is cloning.