Interactive Toy Concepts Ironman - Manual

Lightstars is a registered trademark of Interactive Toy Concepts Ltd. © 2013 All Rights Reserved.
Manufactured by and distributed by Interactive Toy Concepts Ltd. Conforms to Safety Standards ASTM F963 Regulatory Requirements
Meets CPSC Safety Requirements. Products and colors may vary. MADE IN CHINA.
INS-22008-130527-US
Limited 30-day warranty
Product is warranted by Interactive Toy Concepts Limited against
manufacturing defects in material and workmanship under normal use
for (30) days from the date of purchase.
Warranty is validated upon receipt of proof or purchase
and confirmation of UPC code.
Proof of Purchase
PLEASE! DO NOT RETURN THIS PRODUCT TO ANY RETAIL STORE!
For any questions or problems with this product please contact us at:Email: [email protected]
Phone: Inside North America: +1-416-444-6873 Outside North America: 1-866-214-2220
Address: Interactive Toy Concepts, 17 Vulcan Street, Toronto, Ontario, Canada. M9W 1L3 Website: www.interactivetoy.com
Welcome to the Light Stars animated hologram projector
from Interactive Toy Concepts!
The Light Stars requires 4 x AAA batteries to operate!
Alakaline batteries are recommended for best performance.
IMPORTANT: This product includes ‘try-me’ batteries.
Used for demonstration purposes only. Before use, remove
the try-me batteries and replace with the appropriate
batteries specified in this guide.
5+
Item #
22003/22030/22031
22032/22035/22036
22038/22039/22050
22051/22052/22053
22055/22056
1. Open the battery compartment door
located at the bottom of the Light
Stars unit by using a Phillips
screwdriver (not included).
2. Insert the batteries as shown.
Ensure that the + or – polarities match
the illustrations inside the battery
compartment.
3. Replace the battery compartment
door and tighten the screw. Do not
over tighten.
-
+
- +
-
Manufactured by and distributed by Interactive Toy Concepts Ltd.
Conforms to Safety Standards ASTM F963 Regulatory Requirements
Meets CPSC Safety Requirements.
Products and colors may vary.
MADE IN CHINA.
©
IMPORTANT BATTERY INFORMATION
Do not mix old and new batteries, different types of batteries, standard carbon zinc, or alkaline batteries of different capacities. Do not use
rechargeable batteries. Ensure that the contact surfaces are clean and bright before installing new batteries. Please match the correct polarity (- or
+) when replacing batteries. Do not throw batteries into the fire. Replace all batteries of the same type/brand at the same time. The supply
terminals are not to be short-circuited. Remove exhausted batteries from the toy. Batteries should be replaced by adults. Remove batteries if the
toy is not going to be played with for a long time to prevent leakage or other damage. Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are only to be charged under adult supervision. Rechargeable batteries are to be removed from the toy before being
charged. For optimal performance, use only alkaline batteries.
IMPORTANT SAFETY INFORMATION
Do not modify your LIGHT STAR! Any changes or modifications to this product are strictly prohibited and will void product warranty.
ADULT SUPERVISION IS RECOMMENDED AT ALL TIMES!
INSTALLING / REPLACING
BATTERIES (only by Adult)
CONTROL INSTRUCTIONS - OPERATING THE LIGHTSTAR TOY
POWER
ON / OFF
Button
Chapter
Selection
Button
Action
Buttons
POWER ON / OFF Button
Press and hold the POWER button for 1 second, the Light Stars unit will
power on. Repeat the above to power off.
The Light Stars unit is programmed with a power saving feature. The
built-in LED will turn off automatically after 30 seconds if there are no
actions or selection button inputs. The LED will resume operation when
there is any input from an action button.
* If the Light Stars unit is not used continuously for another 30 seconds it
will automatically power off completely.
* If you cannot power on the Light Stars Unit, or the LED is dim after the
unit is turned on, the batteries may have run out of power and need to be
replaced.
* Please follow the instructions in this manual to replace the batteries.
Chapter Selection Button
To cycle through all the different chapters of animations. Pressing this
button takes you to a new chapter where different actions can take
place. Each chapter has its unique actions.
Action Buttons
To activate the playback of different actions which are a unique part of
each chapter.
AGES:
HOLOGRAM PROJECTION FOCUS ADJUSTMENT
If your hologram projection is out of focus, you can adjust this by rotating the focus ring near the top of your Light Stars toy.
Package Contents:
1 x Light Stars Animated Hologram Projector
1 x Instruction Manual