Chapter 12 bypass information – IBASE FWA8206 User Manual
Page 28

FWA8206 Series User’s Manual
16
Chapter 12
Bypass Information
If jumpers are removed from JP4 leaving 1-2 & 3-4 to open status, ETH0 & ETH1 will be under
Bypass mode (Bypass LED off).
User could initiate it to the Normal mode (Bypass LED light up) then re-trigger it in a loop.
Once the system hangs, ETH0 & ETH1 will switch to Bypass mode after timeout.
The following is the example code for the Bypass function.
#include
#include
#include
#include
#include
#include
#include
#include
#include
#include
#ifdef __GLIBC__
# include
#endif
void by_pass_init (void) {
unsigned int i=0;
outb(0x87,0x4e);//Enter extended function mode
outb(0x87,0x4e);
outb(0x2b,0x4e);
i = inb(0x4f);
i &= 0xef;//Configure bit 4 as 0 to be watchdog function.
outb(0x2b,0x4e);
outb(i,0x4f);
outb(0x7,0x4e);
outb(0x8,0x4f);//watchdog in logic device 8
outb(0x30,0x4e);//Active wdt
outb(0x1,0x4f);
outb(0xf5,0x4e);
i = inb(0x4f);
i &= 0xf7;
outb(0xf5,0x4e);
outb(i,0x4f);
outb(0xf6,0x4e);
outb(1,0x4f);//Set timeout value to inital the normal mode.
outb(0xf7,0x4e);
outb(0x0,0x4f);
outb(0xaa,0x4e); // Exit extended mode