Dynaudio BM10S - Manual (Page 21)

19
FACTOR- DEFAULTS
Factory Default settings.
The factory default settings are as follows:
Power Mode:
Automatic
Phase: 0o
Level: 0dB
EXT: On
LF Cut-off: 100Hz
To reinstate the factory default settings:
• Switch the subwoofer off completely using the switch on
the back panel (No.2 in fig.2).
• Wait for at least 10 seconds.
• Press and hold the "A" preset button (No. 6 in fig 6).
• While holding down the "A" preset button, switch on
subwoofer back on: The power Status LED will start to
flash green.
• Release the "A" preset button. The subwoofer is now
reset to the factory default settings.
All previously stored presets will be deleted also
when resetting to factory defaults