Specifications, Control descriptions – Fusion MS-AM702 User Manual

Page 4

1: PWR LED (Blue)

When illuminated the amplifier has been correctly powered up.

2: PRT LED (Red)

When illuminated the amplifier is in protection mode.

3: AUTO ON/OFF

Switch for desired operation. See notes Auto ON/Off operation

4: High Pass (H/P) Switch

Set the appropriate mode of operation. The two positions available are OFF (full range) and H/P. See point 5 below.

5: FREQ Control

Set the crossover switch 4 to H/P and turn this control to 60Hz or above (range 60Hz – 600Hz) when using speakers smaller
than 6 x 9”. This feature is designed to filter out all low bass frequencies. Note: Failure to do so could result in speaker damage.

6: LEVEL Control

The level control on the amplifier allows you to match the input level of the amplifier to the output level of your head unit. Match-
ing the input can be accomplished in three simple steps:

1: Turn the LEVEL control on the amplifier to minimum.

2: Adjust the Headunit to 3/4 maximum volume ensuring that the BASS and TREBLE are set to zero.

3: Adjust the LEVEL control until the desired volume is achieved without audible distortion. Remember, the level control is not a
volume control. Ignoring the three steps above may damage your speakers and/or amplifier.

SPECIFICATIONS

Operating Range +10-16Volts DC / Negative Ground

20 Watts RMS at 4 Ohms per channel @1%THD+N

33 Watts RMS at 2 Ohms per channel @1%THD+N

S/N Ratio @ 1kHz / 1W Reference -- 84dB

High Pass x-over - 60Hz – 600Hz

Maximum Operating Current - 8 AMPS

THD 10% @ 1kHz / 4 Ohm Load per channel

For further product and installation information please visit

www.fusionelectronics.com

Para obtener más información sobre los productos o su instalación, visite
www.fusionelectronics.com

Weitere Informationen zum Produkt und zur Installation finden Sie auf folgender
Website:

www.fusionelectronics.com

Ga naar

www.fusionelectronics.com voor meer product- en montage-informatie

Pour plus de renseignements sur les produits et l’installation, veuillez consulter
www.fusionelectronics.com

Per ulteriori informazioni su prodotto e installazione, potete visitare
www.fusionelectronics.com

За дополнительной информацией о продукции и установке обращайтесь на
www.fusionelectronics.com

PUBLISHED BY FUSION ELECTRONICS LIMITED:

without notice.

YOU CAN HELP PROTECT THE ENVIRONMENT!
Please remember to respect the local regulations:
Hand in the non-working electrical equipment
to an appropriate waste disposal center.

006

WIRING

007

SPECIFICA

TIONS

CONTROL DESCRIPTIONS