FSR DV-HMSW-88 8x8 MATRIX - Manual (Page 10)

10
CRE PRE ENT CAN EDI
1 2 3 4 5 6
----------- OUTPUT -----------------
4.3 Operation by Front Panel Buttons
(1) Input/output channel check:
Push “Preview” button
→ Input # button: current set channels are displayed in sequence
(2) Input/output channel change
Push “Create” button
→ Input # button → Output ## button (Multiple selections) set → Push “Enter” button:
the connection of the channels are changed
* If you want to cancel, then press “Cancel” button.
Example: CH# 1 input to 1,2,3,4 output with same picture
Create -> Input 1 -> Output 1,2,3,4 -> Enter
(3) Save EDID data
1) Set Input Rotary Switch on back panel to “0” Manual set up mode.
2). Disconnect all input port cables on HDMI Matrix
(The power cable of set-top box should be unplugged (not sw. off))
3) Connect HDMI Matrix output to display directly (projector, DVI monitor or AV Receiver),
4) Power on both of DV-HMSW-88 and Display (If you connect AV Receiver, disconnected display from the
Receiver)
5) Push “EDID” button
→ Select one of output # button (which is connected with display) → Input # button to be
set (one or multiple) → Push “Enter”: Read EDID data of display and save them to matrix (after 4~6 sec it will be
light off).
If the light of the buttons is on, then just push “Enter”
6) Turn off all devices
7) Connect all input cables
8) Turn on HDMI Matrix first.
9) Turn on all the Input sources and display (Plug in power cable and turn on set-top box)
(4) Save Preset of switching mode
Push “Create” button
→ Input # button → Output ## button (Multiple selection) set → Push “Preset” button
-> Push “Select” key until LCD shows the number you want (Rotating number)
(5) Recall Preset
Push “Preset” button -> Push “Select” key until LCD shows the number you want (Rotating number) -> Push “Enter”
button
Select
- #: Select only on channel
- ##: Select multiple channels
- All push buttons are on / off toggle (Light ON - Selected)
- If you use DVI display, the EDID data should be saved to matrix switch first.